Full Console

REMOVE OR DISCONNECT
1. Electrical connectors from phone. Set handset aside.
2. Console bin.
3. Cut tie strap securing phone connector, feed wiring through hole in console bin.
4. Screws securing phone mounting plate to console bin.

INSTALL OR CONNECT
1. Hold bin backwards above console and route harness through large hole in bin.
2. Feed 10-way adapter harness through small hole, leaving about 4 inches of slack.
3. Connect 10-way connector to phone adapter.
4. Install tie strap in same location as previously remove.
5. Feed excess slack back into large hole in bin.
6. Phone mounting plate to console bin.
7. Console bin to console, assure phone wiring is free and is not pinched.
8. Press PWR to check for proper electrical connections.