Drive Shaft Assembly, Drive Shaft Seal

REMOVE OR DISCONNECT














1. Pump assembly from vehicle if necessary for access.
2. Retaining ring (11) from housing (6).
3. Drive shaft (8) and ball bearing assembly (10) from housing (6).
^ When clearance exists between drive shaft shoulder and bearing inner race, measure clearance before bearing removal.
^ Bearing (10) from shaft (8).
4. Drive shaft seal (7) from pump housing assembly (6).
^ Clean:
- All parts in power steering fluid.
- Dry parts.
^ Inspect:
- Drive shaft (8) and splines.
- Ball bearing assembly (10).
- If scoring or pitting is noted, replace appropriate parts.

INSTALL OR CONNECT











1. Lubricate new drive shaft seal (7) with power steering fluid.
^ Seal (7) into pump housing (6) using suitable socket.
2. Ball bearing (10) to drive shaft (8).
^ Press bearing to shoulder of drive shaft or clearance measured prior to removal of old bearing. Shaft (8) and bearing (10) into housing assembly (6). Rotate drive shaft so shaft serration engages with pump rotor (22).
3. Retaining ring (11) to housing (6).
4. Pump assembly to vehicle.