Upper Control Arm

REMOVE OR DISCONNECT
1. Raise vehicle.
2. Wheel and tire.
3. Electronic Level Control (ELC) height sensor link.
4. Fuel filler tube bracket and position away.
5. Inner control arm bolt and spacer.
6. Outer control arm bolt.
7. Control arm up over the shock tower to remove from vehicle.

INSTALL OR CONNECT
1. Control arm over the shock tower to install in vehicle.
2. Inner and outer control arm bolts. Place screw jack under outboard end of lower control arm to bring suspension to design position. Inner control arm nuts must be tightened in design position to reduce wind up in bushings.
^ Tighten upper control arm inner and outer nuts to 108 Nm (80 ft. lbs.).
3. Fuel filler tube bracket.
4. ELC height sensor link.
5. Wheel and tire.
^ Tighten wheel nuts to 190 Nm (140 ft. lbs.).
6. Lower vehicle.